Keep out thieves!
Burglary resistance is an important point to be considered when buying new windows as, in most cases, this is where thieves tend to break in. And the burglars will take anything they want; anything but the risk of wasting too much time trying to open a burglar-proof window. Every minute that the window resists a break-in counts. Experience has shown that perpetrators usually give up after only a couple of minutes. That's why the police recommend a burglary protection class of at least RC2 when buying new windows.
With aluplast windows, you have already opted for ultimate safety in the sash.
The fixed interior profile web for the third gasket all around the window frame improves thermal insulation and prevents the sash from being forced open easily.
Breathe easy: With safetec inside you can increase the safety of your windows.
Stress-free living with technology made by aluplast®
Bonded glass panes were first used in the automotive industry, where they soon became industry standard. aluplast recognized the advantages early on and has advanced the technology for the special requirements needed for window construction for buildings.
The window's glass pane is bonded all the way round the profile.The adhesive provides an extra strong bond between the pane and the sash: the best way to prevent the sash from being pried open and also an essential requirement for burglary resistance class RC2.
Burglary protection is the only option! That's why German home owners who wish to protect their house against unwanted visitors can receive state funding in the form of reduced-interest loans and grants from KfW (a German bank specialising in development). This type of funding can be used to get rid of a home's typical weak points, like the windows or front door.
What you need to know:
In the past, a range of resistance classes were used to differentiate between categories of burglary resistance. In September 2011, a new series of European standards was published in relation to burglary protection. The new standard (DIN EN 1627) now differentiates between RC 1 N to RC 6. RC stands for resistance class.
The following table lists the assumed mode of break-in for resistance classes RC 1 N to RC 6.
|DIN EN 1627
|DIN V ENV 1627 (valid until 09/2011)
|Period of resistance
|Type of burglar / method used
|RC 1 N
|Components in this category only offer basic protection against attempted break-ins using physical strength, such as kicking, pulling, etc. In this class, only windows with standard glass are listed.
|RC 2 N
|without safety glass
|Here, opportunist burglars use simple tools, such as screwdrivers, pliers, chocks, etc., to force open the locked component. As an attack on the glass should be ruled out, this glass uses standard glass only.
|The type of burglar and method used are the same as the previous class. However, safety glass in accordance with EN 356 is required from class RC 2 and above.
|The practised criminal uses an additional screwdriver and crowbar to break open the locked element.
|To break in, the experienced criminal uses impact tools, saws and a cordless drill.
|In addition, the experienced criminal uses electrical tools, such as drills, jigsaws, reciprocating saws and angle grinders with a maximum diameter of 125 mm.
|The only difference to the previous resistance class is the use of an angle grinder with a maximum diameter of 250 mm.